Resetting Oil Service
Indicator Lights
Toyota
Toyota Camry,
Solara, Highlander, RAV4, Sienna, Tundra, Avalon, Corolla, Matrix
2004-06
Turn the ignition
key to the OFF position with the odometer reading shown. Turn the
ignition key to the ON position while holding down the trip reset
knob, hold the button down for at least 5 seconds, and the odometer
indicates “000000” and the light goes off. If the system fails to
reset, the light will remain flashing. In this case, retry above
procedure.
Toyota 4-Runner,
Solara 2003-06
Turn the ignition
key to the OFF position with the odometer reading shown. Turn the
ignition key to the ON position while holding down the trip meter
reset button. Hold down the button until the light goes off. Before
the light goes off, it illuminates for 3 seconds, flashes for 2
seconds, and illuminates for 1 second. If the system fails to reset,
the light will remain flashing.
Toyota Prius
2004-05
Press the POWER
switch to the OFF mode with the odometer reading shown. Press the
POWER twice to select the lG-ON mode while holding down the trip
meter reset button. Hold down the button for at least five seconds.
The odometer indicates “000000” and the light goes off. If the
system fails to reset, the light will remain flashing.
Toyota Previa,
1991-97
To reset “OIL CHANGE” light, remove cover from switch
located below speedometer. Insert a thin object into cavity and
depress the switch.
Toyota Cressida,
Supra, 1987-88 w/Super Monitor
When “CHECK ENGINE OIL” is displayed
on Super Monitor, press SELECT (A) button below display until
“ENGINE OIL” mode is displayed (unless it is already displayed).
Then press and hold the SET (B) button until “OK” is displayed.
|
